5 -59
(7) Turn signal light bulb- Replace
② Front turn signal light bulb -
replacement
1. Remove the three screws① retaining the turn
signal light assembly and remove the
assembly.
2. Turn the socket counter-clockwise and remove
the socket from the housing.
3. Push in on the turn signal light bulb and rotate
counterclockwise in the socket to remove the
old bulb.
4. Insert the new bulb into the socket and turn
the bulb in a clockwise direction until
tightened.
5. Install the socket to the housing.
6. Install the turn signal light assembly to the
cover and tighten the retaining screws.
NOTE: For about bulb specification, refer to the
chapter 5-6-(4) in this manual.
1
2
① Rear turn signal light bulb -
replacement
1. Remove the rubber grommet from the socket.
Carefully access the socket not to get hurt by
mug guard bracket.
2. Turn the socket counter-clockwise and remove
the socket from the housing.
3. Push in on the turn signal light bulb and rotate
counter-clockwise in the socket to remove the
old bulb.
4. Insert the new bulb into the socket and turn the
bulb in a clockwise direction until tightened.
5. Install the socket and rubber grommet.
NOTE: For about bulb specification, refer to the
chapter 5-6-(4) in this manual.
1
To Next Page
Loading...
