LS tractor MT573 - Hydraulic and Filter Replacement; Hydraulic Oil Filter Replacement; Power Shuttle Oil Filter Replacement

5 -32
Hydraulic filter
(2) Replacing Hydraulic Oil Filter
 Park tractor on level surface and apply parking
brake and lower implements and stop the engine.
 This filter is attached under the right-hand floor.
 Carefully clean around the filter and set a clean
container under the filter.
 Coat clean hydraulic oil on the packing of new
filter and check the packing is placed well in the
groove.
 Turn the oil filter counter-clock wise to remove
with filter wrench.
 Turn the new filter clockwise to assemble until the packing makes contact with the mounting surface.
Tighten ¾ to 1 turn more after packing contact.
 Run the engine at idle and check any leakage.
 Check the oil level. If necessary, add new oil. For oil specification, see chapter 5-3, “Lubricants and
Capacity” or the last page in this manual.
Power shuttle oil filter
(3) Replacing Power shuttle oil
filter (if fitted)
 This filter is attached under the right-hand step
floor of the power shuttle models.
 Replace this filter with a new one to the same as
procedure of the hydraulic oil filter.
▶ If the filter or oil is very hot, it may cause serious burns. After cooling down the
tractor sufficiently, replace the filter. Do not loosen the filter while engine is running.
Warning
▶ Be sure to stop the engine before loosening the oil filter.
▶ If the filter or oil is very hot, it may cause serious burns. After cooling down the
tractor sufficiently, replace the filters
.
▶Do not throw the exhausted waste oil to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case.
Warning