4 -8
HST type
1. Lift up all the implements (front/middle/rear)
from the ground after starting engine.
2. Set the engine speed more than 1500
rev/min.
3. Place the range gear shift lever on a
suitable position.
4. After pressing brake pedals down, release
the parking brake lever.
5. Press the HST forward /reverse pedal down
slowly to move the tractor.
6. If necessary, press the cruise control switch
upward to fix the driving speed constantly
while driving forward.
▶ If pressing brake pedals or pressing down the lower side of the cruise control
switch, the cruise control drive shall be stopped.
▶ For HST models, there is a switch on the driver’s seat to control engine cut-off for
driver’s safety. If the operator leaves the driver’s seat without safety measures, the
engine shall be stopped automatically. (For further information, see chapter 2-1-(2)).
▶ When driving or working with a HST model, operate it more than 1500 rev/min.
▶ Press the HST forward/reverse pedal slowly. If pressing these pedals hastily, the
tractor might start suddenly.
Caution
Range gear shift lever
Cabin
Brake pedals
HST reverse pedal
Throttle lever
HST forward pedal
Cruse control switch
Parking brake lever
Range gear shift lever
Roll-bar
Parking brake lever
To Next Page
Loading...
Need help?
General
