1 -38
16. Location : On top of the right-hand fender
for roll-bar models, on the right-hand
window glass for cabin models.
-CAUTION;
Periodically, the DPF will require the
regeneration. This is an automatic function
unless inhibited by operator.
1) Automatic : The DPF regeneration lamp will
illuminate indicating the regeneration is needed.
If the operator does not inhibit the regeneration,
the DPF temperature will also come on and the
engine control unit will automatically begin the
regeneration.
NOTE : Under light or no load conditions,
increase the engine RPMs above 2,200rpm
when possible.
2) Inhibit : In case the tractor is operated in
extremely flammable materials, and the operator
wishes to delay the regeneration process, press
downward on the DPF switch for 1~2 seconds.
The inhibit lamp will illuminate and the
regeneration will be postponed.
(Beware : Inhibit is only intended for a few
moments and the DPF must be regenerated. If
the DPF lamp begins to blink, quickly move to a
safe area, move the shuttle to neutral, apply the
parking brake, bring engine to the lowest RPMs
and press up on the DPF switch for 3 seconds.
The inhibit lamp will go off and the engine
control unit will begin the regeneration.)
3) Forced Regeneration : It is possible to force
the regeneration before the shoot is highly
enough for automatic regeneration. To force the
regeneration, shuttle to neutral, apply the
parking brake, bring engine to the lowest RPMs
and press up on the DPF switch for 3 seconds.
- Failure to comply could result in malfunction of
DPF.
- Part No. : 40363308
To Next Page
Loading...
Need help?
General
