3 -17
⑤ Regeneration mode
▶Fire hazard!
During the Diesel Particulate Filter(DPF) regeneration process, the exhaust stack
and fixed hood area becomes extremely hot. Park the machine outside and away
from combustible or highly flammable material.
Failure to comply could result in death or serious injury.
Warning
In this mode, the operator does not have to take
any actions, the system is activated
automatically by the engine electronic controller.
NOTE : The regeneration is the normal operating
mode.
The regeneration will be activated by ECU ;
- When soot’s rate reaches 100% or more.
- When the engine is warmed up enough.
- When the DPF switch is not pressed to the
Inhibited regeneration mode.
NOTE : Regeneration will be lasted for
approximately 15 to 25 minutes.
▶If engine is turned off during the regeneration, soot will not be completely burned
and may increase fuel consumption. KEY-OFF during regeneration mode is not
recommendable because too short operation won’t finish regeneration mode, So,
we recommend to users to operate until all indicator lights are turned off without Key
switch OFF.
NOTICE
12
During the regeneration, the DPF regeneration indicator(1) and DPF temperature indicator(2) will be
turned on.
In case of turning off the engine while the regeneration is processing, the regeneration is to resume
again when restarting the engine.
To Next Page
Loading...
Need help?
General
