III
CAUTION
n Install the inverter on a non-flammable surface. Do not place
flammable material nearby.
Otherwise, fire could occur.
n Disconnect the input power if the inverter gets damaged.
Otherwise, it could result in a secondary accident and fire.
n Do not touch the inverter while the input power is applied or after
removed. It will remain hot for a couple of minutes.
Otherwise, you may get bodily injuries such as skin-burn or damage.
n Do not apply power to a damaged inverter or to an inverter with
parts missing even if the installation is complete.
Otherwise, electric shock could occur.
n Do not allow lint, paper, wood chips, dust, metallic chips or other
foreign matter into the drive.
Otherwise, fire or accident could occur.
OPERATING PRECAUTIONS
(1) Handling and installation
¨ Handle according to the weight of the product.
¨ Do not stack the inverter boxes higher than the number recommended.
¨ Install according to instructions specified in this manual.
¨ Do not open the cover during delivery.
¨ Do not place heavy items on the inverter.
¨ Check the inverter mounting orientation is correct.
¨ Do not drop the inverter, or subject it to impact.
¨ Use the ground impedance of 100ohm or less for 200 V Class and 10ohm or less for
400V class.
¨ Take protective measures against ESD (Electrostatic Discharge) before touching the
pcb for inspection or installation.
¨ Use the inverter under the following environmental conditions:
To Next Page
Loading...
Need help?
General
