LS XR4040 - Using Front-End Loader (if Fitted)

4 -24
① Safety precautions
z Multi-functional joystick lever provides you more
convenient operation for front-end loader.
z When operating the tractor with front-end loader,
The center of gravity of the tractor may be higher,
and the stability of the vehicle may be worse than
unattached vehicle.
-. DO NOT drive fast on a traffic road. The rolling
or tipping of the tractor can be happened easily.
-. When loading/unloading the bucket on a slope,
move the tractor straight against the slope.
-. DO NOT try to approach a stiff slope.
-. Attach the ballast weight on the 3-point linkage
to prevent the overload of the front axle, and to
improve the stability of the vehicle.
z When working with front-end loader, the front
visibility of the tractor may be worse than
unattached vehicle. Have to observe people and
other vehicles around the tractor.
z DO NOT allow to stay people under the front-end
loader.
z DO NOT allow people on the bucket.
z Only install a front-end loader with a parallel
guidance system and use it all the time; this
system will ensure that the load in the bucket will
remain horizontal, regardless of the height of the
lifting booms.
▶After using the front-end loader, lock the joystick lever to prevent the accident.
(if fitted)
▶When leaving the tractor, lower down the front-end loader on ground.
Warning
▶It is not recommended to install a front-end loader on a tractor without cab, which
cannot offer a minimum protection against falling objects. Have to strictly observe
the following precautions;
- Do not lift the front-end loader to a height from which objects may fall or roll onto
the driver.
- Use always the correct attachment (grab forks, buckets.. etc) for the specific task
to perform and ensure that the load is securely kept in place.
Warning
(8) Using Front-end loader (if fitted)
Locking lever
(safety device)
Joystick lever
Lock