3 -13
PTO switch
(11) PTO switch
z The engine starts only when PTO switch is
placed in OFF position for safety.
z After starting the engine, you must comply with
the operation procedure of the PTO switch as
follow.
1. Check the safety around the implement.
2. Turn the PTO switch to ON position to operate
the PTO.
3. Press the PTO mode switch to desired
position. Refer to the following instruction.
4. When the PTO is working, PTO operation
indicator on the instrument panel shall be ON.
5. If you want to stop the PTO temporarily while
operating, push the PTO switch to OFF position.
The PTO operation shall be OFF.
▶ Before attaching or checking the PTO driven equipment,
- Always place the PTO switch in OFF position, and PTO gear lever in NEUTRAL
position.
▶ If the PTO mode switch is placed in MANUAL position, PTO rotates even if the
implement moves up to upper limit. Pay attention to the surroundings to prevent a
accident.
▶ Do not engage the PTO at high engine speed. Sudden engagement can cause
damage to some implements and PTO clutch. Engage PTO at low RPM, and then
raise the engine speed up.
Warning
ON : PUSH AND TURN
OFF : PUSH
PTO mode switch
(12) PTO mode switch
z It is used to select AUTO or MANUAL mode of
PTO operation
z When the PTO mode switch is placed on ;
- MANUAL : PTO shaft will rotate independent
on the clutch pedal or position control lever.
- AUTO : If pressing clutch pedal or lifting rear
implement over the specified position, the PTO
shaft shall be stopped.
To Next Page
Loading...
