4 -18
HitchFixing pin
Hitch pin
(3) Hitch and Drawbar (optional)
z When attaching towing equipments, use the hitch
or drawbar. DO NOT use the 3-point linkage or
other parts. If so, the tractor could turnover.
z Insert the hitch pin and snap pin correctly after
attaching/detaching equipment.
z DO NOT exceed the maximum permissible
vertical and horizontal load as below.
Snap pin
Drawbar
① Hitch
z Vertical load : 900kg (1984 lbs)
z Horizontal load : 3600kg (7937 lbs)
② Drawbar (w/clevis)
z It is used to tow the equipments having 2 axles.
z It is available to adjust the length of the draw bar
after removing snap pin and lock-pin in the right
figure. After adjusting, assemble the pins firmly.
z Vertical load : 400kg (when pulled) (882 lbs)
575kg (when pushed) (1268 lbs)
z Horizontal load : 2800kg (6173 lbs)
▶ Pulling from the tractor rear axle or any point above the axle may cause the tractor
to overturn. Use always the drawbar or hitch for pulling work.
▶ Do not tow equipment without brakes, weighing more than twice the tractor weight.
▶ When locking the hitch or drawbar with pin after aligning to the towing equipment,
apply the parking brake and stop the engine.
▶ Before transporting equipment on public roads, make sure you comply with your
local traffic regulation.
Caution
z Technically permissible towable mass(es) are as below according to type of coupling.
Hitch Drawbar (w/clevis)
Unbraked towable mass 1800kg 1400kg
Independently braked towable mass 3600kg 2800kg
Inertia-braked towable mass 3600kg 2800kg
Hydraulic or pneumatic braked towable mass N/A N/A
Hitch pin
Clevis(optional)
To Next Page
Loading...
