5 -17
(5) Battery check
z Refer to “Batter handling and Notices” (See page 5-30)
(6) Air cleaner (Dry type)
z (See page 5-12 )
(4) Checking Front axle oil
z Open the plug of oil check port and check if there is
oil leakage.
z If necessary, add new oil into the oil filling inlet.
(after 5~10 minutes later, check the oil level again)
z For oil specification, refer to “Lubricants and
Capacity” at the end of this manual.
(See page 5-6)
Oil filling inlet
Oil check port
(7) Hydraulic hoses and Leakage
z Stop the engine and place all the transmission gears in neutral and lower down the implement to the
ground.
z Periodically check hydraulic system for leaks or damaged parts - kinked, crushed, flattened, hard
blistered, heat cracked, charred, twisted, soft or loose covered hoses and fittings.
z Before removing hydraulic components, make sure to check that hydraulic pressure is relieved
completely. The leaks of pressurized oil can cause a fatal physical injury. For further information,
refer to the section, “3-5. Hydraulic system” in this manual.
(3) Checking Transmission oil
z Stop the tractor on level surface and apply the
Parking brake and lower implements to the
ground.
z Clean around oil filling inlet and pull the gauge
straight out.
z If oil level is between “Min” and “Max” of oil
gauge, it means ‘Proper amount’.
z For oil specification, refer to “Lubricants and
Capacity” at the end of this manual.
(or See page 5-6)
▶ The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
To Next Page
Loading...
