4 -1
1. Sit in driver’s
seat and apply
parking brake
2. Place main gear shift, range gear
shift lever, shuttle lever in NEUTRAL
and PTO switch in OFF position.
3. Pull throttle lever to the
middle position of the full
throttle.
4. Turn key switch to ON
and check if the battery
charging indicator and
cold start aid indicator
are ON.
5. Wait until the cold start
aid indicator is OFF.
(about 10 seconds)
6. Depress clutch pedal
fully and turn key switch
to START position. As
soon as the engine starts,
release the key switch to
ON position.
7. Check if the battery
charging indicator is OFF.
If not, stop the engine
immediately and check the
problem.
8. Run engine for a few
minutes to allow engine oil
and transmission oil to
warm up.
4. Operation and Work
4-1. Engine start and stop
(1) Engine start
Caution
▶Check each part before starting the
engine.
▶Check if there is some other people
around before starting.
▶Place all the levers and switches in
NEUTRAL or OFF position.
Brake pedals
Clutch pedal
Main gear
shift lever
4
2
31
PTO switch
OFF
Key switch
OFF
ON/PRE-HEAT
Start
N
Mechanical type
To Next Page
Loading...
