LSIS 004iC5-1 - Page 35

5. Programming Keypad
5-11
How to monitor Motor rpm in Drive group when the motor is rotating in 1730 rpm.
Drive group
1
-. Present run frequency can be monitored in the first code
of Function group 1. The preset frequency is 57.6Hz.
-. Continue pressing the Up () /Down () key until rPM is
displayed.
2
-. Motor rpm can be monitored in this code.
-. Press the Prog / Ent (

) key once.
3
-. Last three digits 730 in 1730 rpm is shown on the LED.
-. Press the Left () key once.
4
-. First three digits 173 in 1730 rpm are shown on the LED.
-. Press the Prog / Ent (

) key once.
5
-. Return to the rPM code.