LSIS 004iC5-1 - Parameter Initialization and Reset

5. Programming Keypad
5-13
 Parameter initialize
How to initialize parameters of all four groups in H93
Function
group 2
1
-. In H0, press the Prog / Ent () key once.
2
-. Code number of H0 is displayed.
-. Increase the value to 3 by pressing the Up (

) key.
3
-. In 3, press the Left () key once to move the cursor to the
left.
4
-. 03 is displayed. 0 in 03 is active.
-. Increase the value to 9 by pressing the Up (

) key.
5
-. 93 is set.
-. Press the Prog / Ent (

) key once.
6
-. The parameter number is displayed.
-. Press the Prog / Ent (

) key once.
7
-. Present setting is 0.
-. Press the Up () key once to set to 1 to activate parameter
initialize.
8
-. Press the Prog / Ent () key once.
9
-. Return to the parameter number after blinking. Parameter
initialize has been complete.
-. Press the either Left (

) or Right (

) key.
10
-. Return to H0.