LTH Electronics MXD73 - Page 160

Setup
MXD70 Conductivity Setup and
Operating Guide
- 41 -
Setup
Setpoints Setup
( available options vary with card type and configuration )
Setpoint 1 Setpoint 2 Setpoint 3 Setpoint 4 Setpoint 5 Setpoint 6 Channel Input Source Trigger High Value Low Value USP Pre-Trigger Mode Cycle Time Proportional Band Delay Hysteresis Dose Alarm Dose Alarm Time Initial Charge Charge Time Charge Access Alarm Mode Clean Duration Clean Interval Clean Mode Clean Recovery Clean Delay