LTH Electronics MXD73 - Setpoint Cleaning Mode

Setpoints
MXD70 Setpoints, Current Outputs,
and Digital Inputs Configuration Guide
- 17 -
Setpoints
Setpoint Cleaning Mode
The Setpoints can be configured to operate a jet spray wash or rotary electrode cleaning system on a
timed cycle. Its purpose is to prevent accumulation of particulate matter on the active surfaces of the
sensor. Note that cleaning is not available on all sensor input types.
Input Source
If available select cleaning from the list of options.
/ – Select Option
EXIT
– Cancel
– Save Selection
Clean Duration
Enter the duration of the cleaning operation.
For the duration of the clean, cleaning will appear in
the associated sensor input display section on the
front screen.
/ – Increase / Decrease Digit

– Select Next Digit
EXIT
– Cancel
– Save Value
Clean Interval
Enter the time between cleaning operations.
/ – Increase / Decrease Digit

– Select Next Digit
EXIT
– Cancel
– Save Value