Instruction Manual
_______________________________________________________________________
_____________________________________________________________________________
BE6043-16 Stand Alone Multipoint System LumaSense Technologies A/S
Page 23 of 25
9.0 Display the Homepage of the gas monitor
The homepage of the gas monitor can be displayed if the gas monitor is
connected to an Ethernet network.
Any web browser can be used to display the homepage of the gas monitor.
The IP address obtained from the Ethernet set-up of the gas monitor can be
entered in the address field of the web browser in order to display the
homepage. For further information regarding how to set-up the Ethernet
parameters in the gas monitor please consult the gas monitor instruction
manual supplied with the gas monitor.
The last measured gas values from the last active channel are displayed
together with information about the gas monitor, like the device serial
number, if water- and cross-compensation is performed.
Error and warning messages will also be displayed on the homepage.
The grey "Update Measurements" link can be used to update the
homepage with the last measurement results.
Figure 7. The gas monitor homepage
To Next Page
Loading...
Need help?
General