Instruction Manual
_______________________________________________________________________
_____________________________________________________________________________
BE6043-16 Stand Alone Multipoint System LumaSense Technologies A/S
Page 24 of 25
10.0 Use BZ7007 to Upload data to a PC.
The BZ7007 Remote and Offline SW can be used during set-up of the
Stand Alone System and to retrieve data from the system. The
BZ7007 can be used either directly connected via a USB cable or
through a LAN network via the Ethernet connection.
The procedure to use the BZ7007 SW with a Stand Alone Multipoint
System is covered in the User Manual BE6042 for the Remote and
Offline Software.
Please consult the User Manual BE6042 for guidance in how to use the
Remote and Offline Software, to Set-up the system and to upload data
to a PC in excel or cvs file format.
It is recommended to upload data with a regular timespan to prevent
data to be overwritten by new measurement data due to the finite
data storage capacity in the Monitor.
Please Notice: When the Gas Monitor is set-up to be the system
controller in the Stand Alone system with a Type 1409 the print
functionality as described in the Gas Monitor User manual Chapter 10
is disabled.
Data logging is still available.
To Next Page
Loading...
Need help?
General