LumaSense technologies Innova Type 1314i - Page 8

Instruction Manual
_________________________________________________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________________________________________________________________
BE6043-16 Stand Alone Multipoint System LumaSense Technologies A/S
Page 8 of 25
Figure 3. Quick Set-up Guide
Please Note:
The Analog/Relay branch is only available when an Analog/Relay Module is installed in a Type 1314i (UA1373) or in a Type 1512(UA1374).
The Multipoint Sampler branch is only available if a Type 1409 is attached to a Gas Monitor (Type 1412i, 3434i, 1314i or 1512)