17
NOTICE:
Indications appear when the parameter 22 will be switch on in the
SETUP mode, i.e. the selection of the harmonic measurement and
the assumptions concerning the measurement will be fulfilled.
4.2.2. Setting time mode - t
After the entry into the SETUP procedure one must choose the mode
t by pressing the
or key and the key. Following
values will be displayed:
By means of keys required values can
be set, i.e. the position of the decimal digit can be choosen by the
or key, the digit value by the or key. The
cursor signalizes the active position. The set value can be accepted
by the key or cancelled by the key and comes back
into the measuring mode.
causes the arrangement on the successive parameter.
after dd (day), causes the transition to hours and minutes
settings.
Where: yyyy - year
mm - month
dd - day
Where: hh - hours
mm - minutes
ss - secondes
To Next Page
Loading...
Need help?
General
