Lumenera Scientific Infinity Camera
Release 3.3 User’s Manual
Copyright 2004 Page iii
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to correct the interference by one
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician.
Any changes or modification to said product not expressly approved by Lumenera could void the user's
authority to operate this device.
Shielded and grounded cables and connectors must be used to meet FCC emission limits. Lumenera
takes no responsibility for any radio or television interference caused by using cables or connectors other
than those recommended.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
European Community (CE) Statement
Products: Infinity 1, 2, 3, 4, 5, X, Lu1175, Lu1175X, Lu1205, Lu1135, Lu1165, Lu1275, Lu1335 and
Lu1375 USB Scientific Cameras.
Directives: 2001/59/EC (General Product Safety Directive) Self-declared 89/336/EEC (EMC Directive).
Standards to which conformity is declared: EN55024: 1998
EN55022: 1998 (Class B)
EN61000-3-2: 1995
EN61000-3-3: 1995
Manufacturer’s Name and Address: Lumenera Corporation
2470 Don Reid Drive.
Ottawa, ON
K1H 1E1
Canada
Type of Equipment: USB 2.0 Scientific Digital Camera
First Year of CE Conformity: 2003
This is to certify that the Lumenera USB 2.0 Scientific Cameras meet or exceed the standards for CE
compliance per the Council Directives noted above. All equipment is built at Lumenera Corporation, and
pertinent testing documentation is available for verification.
To Next Page
Loading...