How to turn on LED floodlight on a Lumens DC-F80?
If the LED floodlight on your Lumens Document Camera is off when you turn on the device, use the control panel to set the LED floodlight to “ON.” The default setting is “OFF”.
What to do if the Lumens DC-F80 image is too bright?
If the output image from your Lumens Document Camera is too bright, too dark, or vague, press the [AUTO TUNE] button. This will automatically adjust the image to achieve the best brightness and focus.
How to fix focus issues on a Lumens DC-F80 Document Camera?
If your Lumens Document Camera is unable to focus, it's possible the document is too close to the lens. Try pressing the [ZOOM -] button on the control panel or physically move the document further away from the lens. After adjusting the distance, press the [Auto Focus] button.
What to do if Ladibug™ and other applications cannot be used simultaneously with Lumens Document Camera?
If Ladibug™ and other applications cannot be used simultaneously, close the currently running applications. Then, start the application you want to use.
Why is there no image output from my Lumens DC-F80 Document Camera?
If your Lumens DC-F80 Document Camera shows no image output, first check the power. Then, check all cable connections. Also, check if the DIP switch is properly set.
Why are the manual steps not working for my Lumens DC-F80?
If the operating steps in the manual are not applicable to your Lumens Document Camera, it may be due to improvements in functions. Confirm the firmware of your machine and check the Lumens website for any updated versions.
General| Image Sensor | 1/2.5" CMOS |
|---|---|
| Frame Rate | 30fps |
| Lamp | LED |
| Image Rotation | 0°, 90°, 180°, 270° |
| Focus | Auto / Manual |
| Document Size | A3 |
| Zoom | 12x digital zoom |
| Shooting Area Max | 420 x 297 mm (A3) |
| Output Interface | HDMI, USB |
| Compatibility | Windows, Mac |
| Light Source | LED |
To Next Page
