How to turn on LED light on Lumens DC-W80 Document Camera?
If the LED floodlight is off when you turn on your Lumens Document Camera, it's because the default setting is “OFF.” Use the control panel to turn the LED floodlight “ON.”
What to do if the Lumens DC-W80 Document Camera image is too bright?
If the output image from your Lumens Document Camera is too bright, too dark, or vague, press the [AUTO TUNE] button. This will automatically adjust the image to achieve the best brightness and focusing performance.
How to focus Lumens Document Camera?
If you are unable to focus your Lumens Document Camera, it might be because the document is too close to the lens. Try pressing the [ZOOM -] button on the control panel or physically move the document further away from the lens. Then, press the [Auto Focus] button.
Why are the Lumens DC-W80 Document Camera manual steps not working?
If the operating steps in the manual are not applicable to your Lumens Document Camera, it may be due to improvements in functions. Confirm the firmware of your machine and check the Lumens website for any updated version.
What to do if Ladibug isn't working with Lumens Document Camera?
If Ladibug™ and other applications cannot be used simultaneously, close the currently running applications before executing the application you wish to use with your Lumens Document Camera.
What to do if Lumens DC-W80 Document Camera has no image output?
If your Lumens DC-W80 Document Camera has no image output: 1. Check the power. 2. Check all cable connections. 3. Check if the DIP switch is properly set.
General| Frame Rate | 30 fps |
|---|---|
| Lamp | LED |
| Microphone | Built-in |
| Power | DC 12V |
| Focus | Auto/Manual |
| Light Source | LED |
| Resolution | Full HD 1080p |
| Zoom | 8x digital zoom |
| Connectivity | HDMI, VGA, USB |
| Shooting Area | A3 (297x420mm) |
| Effective Pixels | 2MP |
| Compatibility | Windows, Mac |
To Next Page
