What to do if the images output from Lumens Document Camera PC193 are too bright?
If the images output from your Lumens Document Camera PC193 appear too bright, dark, or vague, press the [AUTO TUNE] button. This will automatically adjust the image to achieve the best brightness and focusing performance.
Why Lumens Document Camera, Ladibug™ and other applications cannot be used simultaneously?
If your Lumens Document Camera and Ladibug™ or other applications cannot be used simultaneously, it is because only one application can be executed at a time. Please close any currently running applications before attempting to use another one.
What to do if Lumens PC193 is unable to record images?
If your Lumens Document Camera is unable to record images, first, check if the stored data has reached the maximum size of the USB disk. Also, note that the recording function is not supported in the internal memory; ensure a USB disk is inserted for image recording.
How to fix Lumens PC193 Document Camera unable to focus?
If you are unable to focus your Lumens Document Camera, it's probably because the document is too close to the lens. Try pressing the [ZOOM -] button on the remote control or control panel. Alternatively, physically move the lens away from the document to increase the distance, and then press the [FOCUS] button on the right side of the lens for auto focus.
What to do if Lumens Document Camera PC193 fails to store images?
If your Lumens Document Camera PC193 fails to store images or react, first check if the stored data has reached the maximum size of the USB disk (priority) or internal memory. Also, ensure that the capture function is not set to continuous mode and that the time for capture is not set to be too long.
Why the operating steps in the manual are not applicable to Lumens Document Camera?
If the operating steps in the manual are not applicable to your Lumens Document Camera, it may be due to improvements in functions and the manual not being up-to-date. To resolve this, check if the Firmware version of your machine is up-to-date. Please go to Lumens official website to check whether the latest version is available for update.
How to unlock locked Lumens Document Camera?
To unlock a locked Lumens Document Camera device: 1. Press [MENU] on the remote control or control panel to activate the setting menu. 2. Press the arrow buttons to select [Setting]. 3. Press [ENTER] to activate. 4. Press the arrow buttons to select [Advanced] menu. 5. Press the arrow button to [Lock Down]. 6. Press the arrow buttons to select [Off] and cancel the password setting function.
What to do if there is no image output from Lumens Document Camera PC193?
If there is no image output from your Lumens Document Camera PC193, check the following: 1. Check the power. 2. Check all cable connections. 3. Check the [Source]. 4. Check the settings for the source of the projector. 5. Check if DIP switch is properly set.
What to do if Lumens PC193 boot without power signal?
If your Lumens Document Camera is booting without a power signal, make sure you have plugged in the power cord.
Why the data in the USB flash drive cannot be read in Lumens PC193?
If the data in the USB flash drive cannot be read by your Lumens Document Camera: 1. It is recommended to use a USB flash drive with a capacity of 4 G and above (up to 64 G supported). 2. Ensure the file was saved at the specified path: \DCIM\100MEDIA. 3. Verify the file is named appropriately, using four English letters followed by four numbers.
General| Frame Rate | 30 fps |
|---|---|
| Audio | Built-in microphone |
| Max Resolution | 1920 x 1080 |
| Light Source | LED |
| Resolution | FHD |
| Connectivity | USB |
| Sensor | CMOS |
| Shooting Area Max | 420 x 297 mm (16.5" x 11.7") |
| Lamp | LED |
| Image Rotation | 180° rotation |
| Effective Pixels | 2MP |
| Focus | Auto focus |
To Next Page
