English - 34
7.21 I would like to resume the factory default setting
(Factory Reset)
1. Press [MENU] on the remote control or control panel to activate
the setting menu.
2. Press [], [], [], or [] to select [Setting].
3. Press [ENTER] to activate.
4. Press [] or [] to select [Advanced] menu.
5. Press [] to select [Factory Reset].
6. Press [] or [] to select [Yes].
7. Press [ENTER] Execute。
7.22 I would like to change the power on image
<Note> The power on image file must be less than 5 MB and in JPEG
format.
<Note> To save the file, please follow the instruction below:
File path: \DCIM\100MEDIA, for example: J: \DCIM\100MEDIA
File name: four English letters+ four numbers, for example: LUMN0001.JPG
1. Press [MENU] on the remote control or control panel to activate the
setting menu.
2. Press [], [], [], or [] to select [Setting].
3. Press [ENTER] to activate.
4. Press [] or [] to select [Advanced] menu.
5. Press [] to select [Splash Screen Settings].
6. Press [ENTER] to activate.
7. Press [] or [] to select [Power On Image Setting] and press [] or
[] to select [Default/Custom].
8. Press [] or [] to select [Power On Logo Show time] and press []
or [] to set up the time.
9. Skip to Step 11 if your select [Default] in Step 7
10. Press [] or [] to [Power On Image Select] and press [ENTER] to
read selected file.
11. 按[] to [Exit] and press [ENTER] to exit.
7.23 Computer-related functions
Ensure that the USB cable is connected and the drivers are installed
before using the computer-related functions. Refer to Chapter 4
To Next Page
Loading...
