Lumens VC-TR40 User Manual

English-19
5.2.4 Tracking
No
Item
Function Descriptions
1
Camera ID/location
Please refer to 5.2.7 System Settings - Output Setting to display camera
ID/location
2
Preview main
window
Display the screen currently captured by the main camera lens
<Remark> Left-click the detected person in the screen to switch the
tracking object. The tracking object is depicted with a green bounding box
3
Panoramic preview
window
Display the screen currently captured by the panoramic lens
4
People Count
Display the number of people in the screen automatically calculated by the
system
5
Auto Tracking
Start/Stop Auto Tracking
<Remark> Auto Tracking / Auto Framing (Select one only)
6
Auto Framing
Start/Stop Auto Framing
The camera will automatically detect the locations of people, and
automatically adjust the zoom to the most appropriate size to
accommodate all the participants according to change of the number of
people in conference
<Remark>Auto Tracking / Auto Framing (Select one only)
7
Zoom ratio
Zoom In/Zoom Out ratio
8
Pan/Tilt setting
Adjust the Pan/Tilt position of the camera screen
<Remark> When Auto Tracking / Auto Framing is enabled, PTZ settings
are not supported
9
Take Turn
Switch the target one by one from left to right. It will be switched once the
button is pressed
10
Target Id
Display Target Id
11
Gesturing
On/ Off Gesturing function.
Support the following gesture, the tracking target will automatically switch
when the speaker raises both hands.
12
Designated ID
Press it to activate this function. You can switch the ID by clicking the
targeted frame with the mouse.
13
Tracking Mode
Set the Tracking Mode (Everywhere Tracking/Stage Tracking/Center
○
1
○
2
○
3
○
4
○
5
○
7
○
6
○
8
○
9
○
10
○
11
○
12
○
13
○
14
○
16
○
15
○
17
○
18

Lumens VC-TR40 Specifications

General

Brand	Lumens
Model	VC-TR40
Category	Security Camera
Language	English