Lumens VC-TR40 User Manual

English-33
Chapter 6 Troubleshooting
This chapter describes problems you may encounter while using VC-TR40. If you have
questions, please refer to related chapters and follow all the suggested solutions. If the problem
still occurred, please contact your distributors or the service center.
No.
Problems
Solutions
1.
Boot without power signal
1. Make sure you have plugged in the power cord.
2. When using a PoE connection, ensure that the power
supply supports PoE (IEEE802.3af) hubs
2.
There is no image output
from camera
1. Check the power supply or PoE supply functions.
2. Confirm the output signals are in streaming output.
3. Confirm whether the camera resolution can be used
together with the monitor equipment
4. Replace the cables and make sure they are not faulty.
3.
Camera image is severely
delayed
Please use 1080p or 720p 60/50 fps rather than 25/30 fps
signals.
4.
RS-232 cannot be
controlled
1. Confirm the connection is correct (RS-232 In/ Out)
2. Please make sure the Baud rate setting is the same as the
control equipment
5.
Whether the Internet can be
used for operation
Please refer to Chapter 5 Network Function Setting
Description for the Internet usage
6.
The ONVIF software cannot
find the machine
Please make sure that [System] > [Output] > [Camera ID] /
[Location] in the web page uses only English letters or
numbers. The ONVIF software cannot find the machine if
you use special characters and space.
7.
The camera does not save
the relevant parameters
(PTZ, AWB …) after reboot
Please make sure if the Initial Position is set to Last MEM
from the setting menu or web page
1.Setting Menu: System - Initial Position
2.Web page: Live View-Setting–Camera Setting - PTZ -
Initial Position
8.
How to log in the portal
when you forget your
account password
Please contact your Lumens distributor or service center

Lumens VC-TR40 Specifications

General

Brand	Lumens
Model	VC-TR40
Category	Security Camera
Language	English