pressing and holding the ▲ button , display is shown
and the BEG , x.xx , xx - xx : xx(date - hr : min) and then
pressing and holding the ▼ button , display is shown
and the BEG , xx - xx : xx(dd - h : m) and END
xx - xx : xx(dd - h : m) , pressing ▲ or ▼ button to set
the BEG(begin time) , pressing TIME button to setting next vaule
, pressing ENTER button to save the setting and leave the
setting , pressing ▲ button once to check the set state.
If user wants to record %dose every day.Please use the ▼ button
to select R BEG , then press RUN button,
If user wants to rerun %dose Function .Please use the ▲ button
and ▼ button > 2 sec. to reset dose value and time.
If user wants to change RUN or Pause Function.Please press the
▼ button and Enter button to release KEY LOCK.
4-3 Data Hold
During the SPL measurement, press the " ▲ Button " ( 3-3,
Fig. 1 ) once will hold the measured value & the LCD will
display a " HOLD " symbol.
Press the " Hold Button " once again will leave the data
hold function.
4-4 Data Record ( Max., Min. reading )
1) The data record function records the maximum and
minimum readings. Press the " RUN Button " ( 3-4, Fig.1 )
once to start the Data Record function and display
is shown the" REC " symbol .
9
To Next Page
Loading...
