Lutron Electronics DS-2013SD - Set Sampling Time; Auto Power off Management

2) After set all the time value ( Year, Month, Date, Hour,
Minute, Second ),
the screen will jump to " Set sampling time character "
setting screen ( Chapter 7-2 ).
Remark :
After the time value is setting, the internal clock will
run precisely even Power is off ( The battery is under
normal condition, no low battery condition ).
7-2 Set sampling time ( seconds )
When the lower display show " SP-T "
1) Use the " ▲ Button " ( 3-3, Fig. 1 ) or " ▼ Button " (
3-6, Fig. 1 ) to adjust the value ( 0 ~ 3600 sec.)
if press " RUN button " the adjust value will be x 10 increase.
Remark :
If select the sampling time to " 0 second ", it is ready
for manual Datalogger.
2) After the Sampling value is selected, press the
" ENTER Button " ( 3-7, Fig. 1 ) will save the setting
function with default.
7-3 Auto power OFF management
When the lower display show " POFF "
1) Use the " ▲ Button " ( 3-3, Fig. 1 ) or " ▼ Button "
( 3-6, Fig. 1 ) to select the upper text to " YES " or
" NO ".
YES - Auto Power Off management will enable.
NO - Auto Power Off management will disable.
2) After select the upper text to " YES " or " NO ", press the
" ENTER Button " ( 3-7, Fig. 1 ) will save the setting
function with default.
18