Manual Data Logger ( Sampling time set to 0
second )
Press the " Logger Button " ( 3-8, Fig. 1 ) once will
save the data one time into the memory.
Beeper will sound and the upper display will show
" DATALOGGER " indicator along with " REC " marker.
* Exit the data logger function :
Press the " REC Button " ( 3-4, Fig. 1 ) > 2 seconds.
d
Memory full
Under execute the data logger, if the bottom right
display show the " Full ", it indicate the memory data
already over 16,000 no. and the memory is full.
e)During execute the Auto Data Logger function, press the
Logger Button " ( 3-8, Fig. 1 ) once will stop to execute
" the data logger function, the " DATALOGGER " indicator
will be disappeared.
If press the " Logger Button " ( 3-8, Fig. 1 ) once again
will continuous the Auto Data Logger function.
Remark :
1)
If intend to change the data logger sampling time,
please refer chapter 9-4, page 36.
2)
If intend to know the space of balance data numbers
into the memory IC, please refer chapter 9-1, page 35.
3)
If intend to clear the saving data from the memory
please refer chapter 9-2, page 35.
8-4 LCD Bcklight ON/OFF
After power ON, the " LCD Backlight " will light
automatically. During the measurement, press the
" Backlight Button " ( 3-2, Fig. 1 ) once will turn OFF the
" LCD Backlight ".
Press the " Backlight Button " once again will turn ON the
" LCD Backlight " again.
33
To Next Page
Loading...
