Lutron Electronics WA-2015 - 9-9 Set DO height (meter ) compensation value; 9-10 Set DO height ( feet ) compensation value

9-9 Set DO height ( meter ) compensation value
When the lower display show " High- "
1)This function only for the DO ( Disolved oxygen ) mode
of adjusting the probe's height compensation value in
meter unit. The default value is 0 meter.
2)Use the " Button " ( 3-9, Fig. 1 ) or " Button " ▲▼
( 3-10, Fig. 1 ) to select the upper value to the desired
height compensation value ( meter ), then press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value temporally.
9-10 Set DO height ( feet ) compensation value
When the lower display show " Highf "
1)This function only for the DO ( Dissolved oxygen ) mode of
adjusting the probe's height compensation value in
feet unit. The default value is 0 FEET.
2)Use the " Button " ( 3-9, Fig. 1 ) or " Button " ▲▼
( 3-10, Fig. 1 ) to select the upper value to the desired
height compensation value ( feet ), then press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value temporally.
39