Lutron Electronics WA-2015 - 9-7 Set pH manual Temp. compensation value; 9-8 Set DO salt% compensation value

2)After Display unit is selected to " C " or " F ", press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
9-7 Set pH manual Temp. compensation value
When the lower display show " t-SEt "
1)This function only for the pH measurement of
adjusting the pH electrode's manual Temp.compensation
value. The default value is 25 ( 77 ).℃℉
2)Use the " Button " ( 3-9, Fig. 1 ) or " Button " ▲▼
( 3-10, Fig. 1 ) to select the upper value to the desired
Temp. compensation value ( or ), then press the ℃℉
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value with default.
9-8 Set DO salt% compensation value
When the lower display show " SALt "
1)This function only for the DO ( Dissolved oxygen ) mode
of adjusting the probe's salt% compensation value.
The default value is 0% salt.
2)Use the " Button " ( 3-9, Fig. 1 ) or " Button " ▲▼
( 3-10, Fig. 1 ) to select the upper value to the desired
salt% compensation value, then press the " Enter
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value temporally.
38