Please Take Note Of The Following:
Ducting kits are used to vent you’ re kitchen odors to the outside of the house, and we recommend
that only Luxair ducting kits are used with our products, this will also assure you that the
product’s warranty is not affected
All Luxair cooker hoods must be fitted with 125mm-150mm ducting. This
must not be reduced in any way for the entire length of its run, it must also
not exceed 3.5mtrs in length from the top of the motor housing connection
to the outside vent plate unless the motor size exceed 980m3/hr (applies to all wall mounted and
Ducting must be fitted to
the out-side of the
reducer collar and
secured with a zip
fastener, also the d ucting
must b e aluminium and
conform to fire
regulations.
Kits can be purchased
setting measuring from
the underside of the
extractor, to the top of the
gas hob is 750mm
And 650mm on electric
hobs, please note that
when using a hob larger
than 60cm please set the
minimum height to 750mm
Warning:
Luxair will not cover the warranty
if you have installed the cooker
hood on either,
100mm ducting, or an old or
existing ducting used by a previous
appliance.
To Next Page
Loading...
