M-Audio FireWire 1814

You will see the M-Audio FireWire 1814 control panel icon in your system tray (lower
right corner of your desktop). Click on the icon to open the control panel.
Mac OS X
Never connect or disconnect the FireWire 1814 while the computer is on. Also, if you’re
going to use bus power, we recommend that you connect the FireWire cable before
turning on the FireWire 1814’s power button.
Installation NOTE: There are differences in administrator authorization between OS
10.2.X, and OS 10.3.X. For 10.2.8 or higher, you may be prompted for your
administrator password at the beginning of the installation. For 10.3 or higher, you may
be prompted for the password just before the installation begins.
1. Insert the Driver CD-ROM into your CD-ROM drive and browse to the CD-ROM to
view its contents. Locate and open the “FireWire 1814” folder, then open the folder
for OS X.
2. Double click the M-Audio FireWire 1814 Installer.dmg file. An icon labeled
”FireWire 1814” will appear on your desktop.
3. Double click on the FireWire 1814 icon. The file named M-Audio FireWire 1814
Installer.mpkg will appear. Double click on the installer file.
4. The introduction screen will now appear. Click “Continue” to proceed.