Headphone Source Assigns – You can monitor the FireWire 1814’s analog 1/2, 3/4, or
aux output busses via the headphone outputs. Using the Headphone Source Assigns
you can select any one of these three output buses to route to the headphones.
Headphone Mute button - Selecting the mute button (the button turns red) will cause
the headphone channels to cease audio output. Deselecting the mute button will resume
audio output on the headphone channels.
Metering – At the bottom of the output page, software level meters are provided for the
FireWire 1814’s analog and digital inputs, as well as the analog software return channel
inputs. This is provided as a quick reference to what’s occurring in the mixer page.
Hardware Page
The hardware page gives you access to important information and functions of the
FireWire 1814.
The hardware page design and function will vary slightly, depending on your platform and
operating system. Shown below is the hardware page from a Windows installation.
Hardware page – adat enabled, S/MUX checkbox displayed lower left
To Next Page
Loading...
