Two headphone outputs are provided on the front panel with dedicated rotary level
controls. The front panel A/B selector switch is designed to give you control over your
input monitoring, or give you immediate access to selectable stereo monitor
sources—you make the choice from the software Control Panel. The main front panel
rotary encoder can be assigned via the Control Panel to adjust a variety of software or
hardware levels, while the FireWire 1814 can be powered via the FireWire bus for total
portability.*
*Bus powered six-pin FireWire connection only. Use the DC power adapter for four-pin FireWire operation.
Mounting the device to a rack drawer
Holes are located on the left and right of the bottom of the FireWire 1814. You can use
the included screws to mount this device to a rack tray as shown below. The FireWire
1814 is mountable on either the left or right side of the drawer. If you choose to mount the
device to a rack tray, you must first remove the rubber pads from the base of the unit.
To Next Page
Loading...
