you want to have a quick conversation without losing the groove, then return to your
previous listening level.
Mixer Page
The mixer page provides output routing and control of the FireWire 1814’s analog
inputs. There are up to twelve virtual channels returning from your Digital Audio
Workstation software. A scroll bar is located at the bottom of the mixer page, allowing
you to access any of the mixer channels as needed.
NOTE: When we say “up to” a number of channels, we are referring to the fact that the
number of channels in the mixer page (as well as the output page) may change
according to your use of the optical port for ADAT or S/PDIF, including whether ADAT
Optical is being used in 8-channel mode or in 4-channel mode at 88.2k or 96kHz
sampling rate—all of which is covered in the hardware page section. For now, we will
assume that the optical port is configured for ADAT 8-channel operation, which is the
default setting.
The following control panel images display various configurations of inputs and outputs
(ie: S/PDIF or ADAT, etc…). Use the scroll bar to display all channels in the mixer page.
Mixer page (left scroll) – adat rtn bus enabled
To Next Page
Loading...
