Panning - The input channel pairs also offer virtual pan pots. As with any typical mixer,
the pan works in conjunction with the Output Routing assign buttons to enable you to
route the signal as you wish.
Ctrl button – When aux send is selected under the panel’s right-side level controller
assignment, the ctrl button will appear under the aux output master channel faders. For
more information, see “Level Controller Assignment” in the “Global Menus” section, below.
Metering - At the bottom of the mixer page, software level meters are provided for each
of the FireWire 1814’s output busses, as well as the aux bus. This is provided as a quick
reference to what’s occurring in the output page.
Output Page
The output page provides you with control over each of the FireWire 1814’s analog and
digital outputs, as well as control of the aux bus and two phones (headphone) buses.
Output page – adat bus enabled @ 44.1kHz
To Next Page
Loading...
