M-Audio FireWire 1814

6. You will then be presented with a list of steps to be performed once the installer
finishes. Read these steps then press “OK.”
7. Once the installer is finished, shut down your computer. When your computer has
powered off, connect the FireWire 1814 to your computer’s FireWire port and turn
on the power. Once the FireWire 1814 is connected, you may turn on your
computer.
8. Once the operating system is loaded, enter the Control Panel under the Apple
Menu, and select “Sound.” Then select the “Output” tab. Click on M-Audio FireWire
1814 to select FireWire 1814 as your default audio device.
First Time OMS Configuration Instructions
Go to the Control Panel or Chooser under the Apple Menu, and make sure AppleTalk is
turned off (this is recommended, although OMS will sense that it is on and prompt you to
turn it off). If you are installing your FireWire 1814 driver and configuring OMS for the
first time, follow these instructions to configure OMS.
1. In the Opcode folder that you will find on your hard drive, locate the OMS
Applications folder, then OMS Setup. Double click on OMS Setup. (OMS setup can
sometimes be done from within your music application.)
2. OMS will inform you that it has not yet been configured. Click “OK.”
3. The Create A New Studio Setup dialog box now appears. Click “OK.”
4. The "OMS Driver Search" box asks you to choose the port on which you've
attached the FireWire 1814 (either Modem or Printer). DO NOT choose a port.