MacDon A30-D - OPERATION; OWNER;OPERATOR RESPONSIBILITIES; OPERATIONAL SAFETY

UNLOADING AND ASSEMBLY
Form 169078 Revision C
25
M200 WITHOUT REVERSER VALVE
a. Remove the plug from port “R2” on valve block
(A) and the cap from fitting in port “R2” on valve
block (B). Ports may not be identified.
b. Remove female coupler assemblies (C) and (D)
from hoses in bundle (E) from header.
c. Remove and discard the cap (F) and adapter
fitting (G) with O-ring from the large coupler (H).
d. Install larger coupler (H) onto fitting at port “R2”
on valve block (B).
e. Remove cap from smaller coupler assembly (C)
and install assembly in port R2 on valve (A).
IMPORTANT
Make sure O-ring is on JIC threads in port
R1 to ensure a proper seal with the
coupler (H). If O-ring is missing, re-use
O-ring from fitting (G).
f. Proceed to Step 16. ATTACH HYDRAULICS.
E
C
D
LARGE COUPLER ASSEMBLY (D)
F
G
H
M200 WITHOUT REVERSER
R2
R2
A
B
M200 WITHOUT REVERSER
C
H
A
B