200 ENGINE ASSEMBLY
Page 6-67
Figure 6-78 — Installing Outer Coupling
2. Loosen the three injection pump rear
support bracket-to-cylinder block capscrews.
Then hand tighten the capscrews until snug,
and loosen 1/4 turn. The lower support
bracket should move freely from side to side.
Figure 6-79 — Lower Support Bracket Adjustment
3. Loosen the two upper support bracket-to-
fuel injection pump capscrews.
Figure 6-80 — Outer Upper Support Capscrew
Figure 6-81 — Inner Upper Support Capscrew
4. Align and slide the fuel injection pump and
adapter over the two alignment dowels.
Figure 6-82 — Aligning Pump Over Dowels
200441a
200442a
200443a
200444a
200445a
5-101.bk Page 67 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
