Page 6-68
200 ENGINE ASSEMBLY
5. With the fuel injection pump positioned over
the alignment dowels, in one motion, lift the
rear of the pump and slightly rotate the
Econovance hub. Slide the pump forward
into position.
Figure 6-83 — Rotating Hub
6. To secure fuel injection pump, install the
lower pump adapter mounting capscrew and
then remove the alignment dowels.
Figure 6-84 — Securing Fuel Injection Pump
7. Install and torque the remaining fuel
injection pump adapter mounting capscrews
to 40 lb-ft (54 N폷m) using torque wrench
J 24407 or equivalent.
8. Install and torque the two link-to-support
capscrews to 40 lb-ft (54 N폷m) using torque
wrench J 24407 or equivalent.
Figure 6-85 — Torquing Link Capscrews
200446a
200447a
200449a
5-101.bk Page 68 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
