33
English
If you intend to log rover raw data, check on the Data
Recording option, set the recording interval in seconds,
define the media where to store the data (SD Card or
Internal memory) and enter a Unit ID. Reminder: This
parameter is used as the header in raw data filenames.
5. Tap OK to enter all these settings and complete the rover
configuration.
Initializing the Rover
1. Tap on the RTK Initialization button (Equip tab)
2. Select the type of initialization you wish to use (see oppo-
site) and then follow the instructions on the screen.
NOTE: Except for “On The Fly Initialization”, the message
“Please do not move the antenna until the position is Fixed!”
will appear when you choose an initialization method. Tap
OK to close this message window.
3. After you have selected an initialization method, FAST
Survey will switch to the Monitor/Skyplot screen. This
screen shows the progress of the initialization phase
(HRMS, VRMS, Status, Latency, etc.).
4. A beep can be heard when the position solution is fixed.
You can then tap BACK at the top of the screen and move
on to your survey, taking care not to lose system initializa
-
tion.
To Next Page
Loading...
Need help?
General