48
English
Stop & Go Survey Rover Setup
1. Turn on the receiver by pressing the red key.
2. Double-tap the Surveying icon.
3. If you have a ProMark3 RTK, press MENU, tap Receiver
Mode and then Post-processing.
4. Press the NAV key until you see the Satellite Status screen
(see opposite). Wait until at least 4 satellites are received.
5. When there is enough satellites received, press the LOG
key. The Survey Settings screen opens.
6. Enter the following parameters:
• Site ID: A 4-character string.
• Survey Mode: Stop -and-go.
• Site Description: An optional 20-character narrative
description of the point.
• Antenna Height: Distance from the rover antenna
mounted on the bar to the ground.
• Units: Antenna height unit (meters, US feet or Int feet)
• Height Type: Slant or Vertical.
• Recording Interval: Time in seconds between any two
consecutive acquisitions of GPS data. Make sure the
same recording interval is used at the base and in the
rover.
• Initialize: Bar.
• Time on Site (sec): Occupation time on initializer bar for
the rover antenna (default: 300 seconds).
Satellite Status screen
VerticalSlant
To Next Page
Loading...
Need help?
General