Maggi BORING SYSTEM 35 - 4. Accessories; 5. Safety Protections Devices and Adhesive Warning

Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
Fig. G Fig. H Fig. I
Fig. L
Fig. F
5. SAFETY PROTECTIONS DEVICES AND ADHESIVE WARNING
− The operator assigned to the machine must be well trained on its correct use, its safety protection devices
and its accessories.
− The machine drilling devices must be correctly blocked and adjusted.
− The whole machine must undergo ordinary and extraordinary maintenance procedures, following the
scheduled timing.
− Before you switch on the machine or start any work session, verify that the working table is free of the
shaving left from the wood previously drilled.
− Before making any operation with the machine, verify that the entire working area is free of persons and of
any obstacles which could be potentially source of danger.
− Verify that the connecting cable to the electrical power supply is safe, well stretched out and not rolled up.
− Do not enter the drilling zone before turning off the machine.
− Do not put any inflammable substances nearby the machine because of risk of explosion and/or fire due to
possible sparks production.
− The operator must pay maximum attention using the pneumatic pedal to work with the machine.
− The operator must think carefully about possible consequences before approaching with his hands the
most dangerous areas of the machine: the drilling zone and the working area of the clamp units.
− The machine must be turned off when not in use.
4. ACCESSORIES
CODE DESCRIPTION
36000061
BUSHES FOR QUICK CHANGE DRILL
See Fig. A
26054810 ALUMINIUM FENCE WITH 4 STOPS ( 1500 + 1500 mm ) See Fig. B
26054812 ALUMINIUM FENCE RH WITH 2 STOPS ( 1500 mm ) Without Fig.
29970202 FENCE EXTENSION ( 1000 mm ) See Fig. C
26050801 EXTRA STOP FOR ALUMINIUM FENCE See Fig. D
26001058
REFERENCE FENCE FOR QUICK AND EXACT SETUP OF STOPS ON THE LONG FENCE FOR LNE BORING (1088 mm)
See Fig. E
29900100 STOP REFERENCE PIN FOR LINE BORING See Fig. F
26000069 SET OF REFERENCE FENCES FOR MOULDINGS AT 45° AND 90° See Fig. G
26000071 REFERENCE STOP TO MATCH THE LONG PANEL DURING TRANSVERSE BORING See Fig. H
26000061 REFERENCE FENCE FOR REAR FENCE PARALLELISM ( 500 mm ) See Fig. I
29971019 EXTRA CLAMPING PRESSER See Fig. L
26054813 ALUMINIUM FENCE LH WITH 2 STOPS ( 1500 mm ) Without fig.