WARNING SYMBOL: ALL THE OPERATIONS HIGHLIGHTED WITH THIS SYMBOL ARE DANGEROUS
TO THE OPERATOR; PLEASE BE VERY CAREFUL IN DOING THESE OPERATIONS.
The main risk is due to moving drills. Our machine is equipped with following protection devices to reduce risks
to the minimum:
A) Emergency push button
It is inserted in the control panel, in the front side of the machine. All the movements of the machine stop im-
mediately when the emergency push button is pushed.
B) Series of stickers and plates
They describe in details all the safety instructions, the correct working procedures and identify the main parts
of the machine. One plate shows the identification and serial number of the machine.
C) Safety clamp (patented)
They are on the surface of the working table or of the already positioned working piece, so that the operator
can not put unintentionally his hands below.
D) Safety protection device
No-way-back coil preserve against accidental start. No-way-back coil preserve against accidental start
Code 36054018 Code 36054019
CEE, ISO, UNI WARNING SYMBOLS
Code 36054016 Code 36054032
To Next Page
Loading...