8. INTENDED USE
8.1 MATERIALS
The boring system machine has been designed and built to drill the following materials:
- solid wood
- m.d.f.
- panels of shaving wood, laminated wood, ennobled wood, etc.
The maximum panel thickness is 65 mm and its maximum dimensions are those described at chapter 7.
- Other materials, different from the ones described above, can be machined only after the written approval of
the manufacturer. In particular it is not allowed to machine materials having toxic or dangerous substances
for operator’s health and safety, metals or other materials that can modify the correct working of the machine
or cause fire or explosion..
- Any modification is forbidden without the written authorization of the manufacturer.
- It is not allowed to tamper with the safety protection devices.
8.2 IMPROPER USE
Any operation that does not comply with the instructions given herein is to be regarded as improper use.
Moreover:
WE ADVISE YOU NOT TO lay tools against or on the machine for any reason whatsoever during machine
installation, use or maintenance.
WE ADVISE YOU NOT TO get on the machine or on any of its parts.
The manufacturer cannot be considered liable for
any damage caused to people, animals or property
resulting from improper use of the machine.
9. TRANSPORT
The boring machine 35 is packed in a wooden box and/or in cardboard and nylon. It is possible to move it by
means of:
• Forklift
• crane
• transpallet
Weight data are written in chapter 8. Before moving the machine verify that the entire surrounding area is free
of obstacles. In case of stocking, the machine must be kept in dry places, away from rain, snow or humidity.
During all moving operations we recommend to be extremely careful to avoid danger of damage for persons,
things and the machine itself.
To Next Page
Loading...