SERVICE
BEFORI CALLING A SERVICER, CHECK THE FOLLOWING:
PART OR ALL OF YOUR _sthe oven plug disconnected from the electrical outlet? ° Are house fuses blown or
OVEN DOES NOT OPERATE circuit breakerstripped? • Isthe ovenplug 1Doseor improperlyplugged in? Has power
supply to your home been interrupted? ° Was oven properly set?
CONTROL WILL NOT AC- This may indicate a "stuck" pad. Press each of the seven pads to disengage the pad.
CEPT AN ENTRY Then, press STOP/CLEARpad andreprogram the operation. Ifthe control stiltdoes not
accept an entry after checking each pad, call the servicer.
FOOD NOT BAKING SATIS- Are racks properly in place and in correct positionfor what you are baking? • Isoven
FACTORILY level? • Areyou usingthe properpan? • tsit bright, notsoiledor darkcolored? • Have
you used foil incorrectly? ,,Are you using standard measuring utensils? = Did you
preheat if recommended? °Oventemperatureisincorrectlyset-toolowortoohigh.
OVEN DOES NOT OPERATE Is the oven disconnected from the electrical power? • Was oven properly set?
OVEN LIGHT DOES NOT is bulb looseor burned out?
WORK
F PLUS A NUMBER APPEARS This is called a FAULT CODE. Ifa fault code appears in the display, press the STOP/
IN THE DISPLAY AND A CON- CLEAR pad. Ifthe fault code reappears, disconnect power to the oven and callthe ser-
TINUOUS BEEP SOUNDS. vicer.
(EXAMPLE: F 2)
EXPLANATION OF FAULT CODES DURINGNORMALOVENCOOKING
Yourappliance isequippedwith an electronic controlfeatur- If afau{t code appears in the display and continuous beeps
ingbuilt-in, self-diagnostic software.This software continu- sound, press the STOP/CLEAR pad. Then, reprogram the
ously monitorsthe control to insure safe and proper opera- cooking operation.
tion.Ifthe softwareshould detectaquestionable situation,a
FAULT CODE (F plus a number) will appear inthe display Ifthe fault code reappears in the display, carla servicer. Do
and continuous beepswilt sound, not use the oven until the control has been serviced. The
surface unit can be used.
_ __ !II I J_ T DURINGASELF-cLEANCYCLE
-- If the oven is heavily soiled, excessive smoke and flaring
may result in a faurtcode, If this occurs, press the STOP/
CLEAR pad and allow the oven to cool for an hour. Then,
reprogram the oven for the clean cycle.
Afaultcode indicatesthatthere maybe functional error.Asa
safety precaution, the control will automatically cancel the ifthe fault code reappears in the display, ca_la servicer. Do
program.Followthe procedures describedto check the ap- not use the oven until the control has been serviced. The
pliance, surface unit can be used.
-12-
To Previous Page
Loading...
Need help?
General
