43
E x a m p l e : If the remote start runtime of option 1-03 is to be set up as 3 min;
_
Press buttons
I + II
for more than 2 seconds. (The remote will beep, and scroll:
“option set-up entry”across the screen.)
_
Press button
I V
for 0.5 sec. (3 times) to select a remote start run time option.
(Option 1-03.)
[(
/
)
, flashing, “1 - 0 3 ”Will display for 1 sec. right after the selection
of the option.
]
_
Press button
I
for 0.5 sec. to select the setting you wish to change to.
(In this case, until “3 : 0 0”is displayed)
_
Press button
IV
for more than 2 sec. to apply the option change to the main con
t r o l l e r .
_
“g o o d”should be displayed on remote.
※ Following the above methods, several options can be set up at the same time. You
do not need to apply the changes after each option change. You can change all of
the options than apply them all to the main controller at once.
To Previous Page
