Magicfx SPARXTAR SPARK FX - Safety Zone and Precautions; Safety Zone Requirements; Additional Safety Precautions

MAGICFX® SPARXTAR — User and Installation Manual 13
WARNING
Always create a safety zone with a distance of 3 m around the
eect of the MAGICFX
®
SPARXTAR. Furthermore, keep a clearance
of 2 m from the set eect height.
Note that the zone shis accordingly when the machine is
installed in a tilted position.
Note that overlap of safety zones in a setup with multiple
machines is allowed, as long the air inlets are not obstructed.
3 m
top view
WARNING
Missing or obscured safety symbols on the machine can lead to
death or serious injury. Make sure all safety symbols are correctly
in place, see section 2.4.
CAUTION
The output pipe heats up during operation and causes burns
when touched. Do not touch the output pipe of a (recently)
powered machine.
CAUTION
Any material that blocks the output pipe can result in injuries, re
and damage to the machine when the machine is used. Always
inspect the output pipe before operating and remove any
obstructing material.
CAUTION
Only open the hopper lid when the machine is not powered.
CAUTION
Do not obscure the air inlets on the side of the machine.
Obscured air inlets can result in injuries, re and damage to the
machine when the machine is used.
NOTICE
Always keep the machine dry and do not let any liquids such as
rain or snow wet the machine.