Magicfx SPARXTAR SPARK FX - Clean Up Procedure

MAGICFX® SPARXTAR — User and Installation Manual 23
 CLEAN UP
1. When nished, set the DMX value for  between 0 and 63 to turn o
the eect.
NOTICE
During the particle removal by DMX, sparks could be visible that
leave the machine.
NOTICE
When particle removal by DMX is not possible, the remaining
particles can be removed by the feature Purge powder from the
display menu, see Section 1.7 on page 8. This feature can
only be activated when the machine is cooled down. Note that
particles could leave the machine during purging.
NOTICE
Not removing the remaining particles aer use can shorten the
machine’s lifetime.
2. Make sure the remaining particles will be removed from the heater by setting the
DMX value for  between 64 and 127. The heater purge will start aer
a delay of 10 seconds. The purge itself takes 10 seconds and will stop
automatically.
3. When all particles are removed, set the DMX value for  between 0
and 63 to stop.
4. Deactivate the safety address. The FX LED indicator on the machine dims.
5. Disconnect the machine from the power source. The machine stops heating.
6. Make sure that the machine has cooled down.
 Disconnect all DMX and power cable(s).
 Remove any powder residues from the machine and surroundings.
NOTICE
To prevent scratching, clean the machine in the following order:
a. Slightly purging air
b. Using a vacuum cleaner
c. Using a towel
9. Unmount the machine if necessary.
Open the lid of the hopper.
11. Li the machine to one side to empty the hopper.
NOTICE
Optionally use a Powder Removal Funnel for emptying of the
hopper, see Section 1.5 on page 7.
NOTICE
Pay special attention to residues and dust inside the hopper. Clean
the hopper interior and lid thoroughly (e.g. with a small brush).
WARNING
Consult the MSDS from our website for detailed safety instructions
for handling and working with the powder.